4-Ch. Speaker Selector System
Features:
- Convenient Audio Control for Up to 4 Pairs of Speakers
- Home Theater Stereo Amplifier System Support
- Independent Audio Source Channel Volume Controls
- Input/Output: Screw Type Connector Terminals
- Compact Desktop / Tabletop Receiver Design
- Front Panel Button Control Center
- Master Power Switch
- Built-in Electronic Overload Protection Circuitry
Technical Specs:
- Power Handling: 100 Watt MAX Per Audio/Speaker Channel
- Speaker Selector Type: 4-Channel
- Speaker Cable Wire Support: Up to 14-Gauge (14 AWG)
- Minimum Impedance: <8 Ohm
- Frequency Response: 20Hz-20kHz
- Dimensions (L x W x D): 16.9'' x 6.3’’ x 3.0'' -inches
QUESTIONS & ANSWERS
Ask a Question-
what specific kind or make of banana plug do you reccomned? They holes seem quite short.
-
My amp manual says "Do not connect the output of this amplifier to any headphone adapter, speaker switch or any device that uses common ground for left and right channels". Can I use a Pyle speaker selector with such an amplifier? This is a newer Class D amp with very different architecture from traditional amps.
please check amplifier specification for compatibility or contact the manufacturer
-
Can you run this with a car stereo amplifier, for eg. Pioneer GM-D8604? Which gives 2 or 4ohm
The PSLSW4 is not intended for car audio requirement is a minimum of 8 ohms impedance
-
What office ceiling speaker would I use with this system? I will need 8 speakers low background music only
PDIC60
-
Can I use 2 of these on one amp? One for “A”speakers,one for “B”speakers.
NO, only one selector per receiver