Bluetooth Home Theater Hybrid Amplifier P3001BT
What’s in the Box:
Extend Warranty Protection and Earn Rewards. Click HERE for Registration
QUESTIONS & ANSWERSAsk a Question
can this unit push a passive sub?
The unit does not have a built-in crossover for low frequency drive
I recently purchased the Pyle 66bt Power Amp. It says it can do 2 to 8 ohms. However there's no switch and I'm not sure how to change between 2 and 8 ohms. I am using it for some transducers / butt-kickers and I need both 4 and 8 ohms.
There is no switch. it is the way you connect the speakers to the unit 4 pcs of 8 ohms in parallel will sum up to 2 ohms
How do I bridge this unit for 2 or 4 ohm duel voice coils?
There is no option to bridge the amp
How can I control my left speakers from my right speakers Would I have to buy some device to have this done? I am patiently waiting on your answer. Thanks Owen
The unit is not equipped with a Balance control
What is the best way to have my computer feed through the receiver? Owen
I need a replacement remote for my Pyle P3001BT. Please let me know how to obtain a replacement. Thank you
The remote control is currently out of stock
How do I connect the wireless microphone to my 3000 watts amplifier
You can use a 1/4" to 1/4" Cable or 1/4" to XLR
My Bluetooth antenna broke and I can’t connect to it with my cell anymore how can u fix it
You can check this one if it is the same with what you have
All 4 wired speakers work fine when connected to RCA, or AUX. When BT is engaged, only 2 speakers work. Is there a firmware update for this or what can i do? Try turning the unit off and turning back on and connect to Bluetooth again Seriously? Like I wouldn't have done something that easy??? I did that, along with 4 different BT devices. Same result. Something is wrong with the BT module. If this is your support line...it seriously needs work
If this is happening on a Bluetooth Mode then it is an issue Channels A & B are normally linked together. whatever comes out of channel A should come out on channel B as well since there is no selector mode for switching speakers.
All 4 wired speakers work fine when connected to RCA, or AUX. When BT is engaged, only 2 speakers work. Is there a firmware update for this or what can i do?
Try turning the unit off and turning back on and connect to Bluetooth again
Can u select a radio station or does it scan stations for u
You can only Scan and search stations
Hello, I want to order the amplifier, I can not understand one thing, how many channels are in the device, and how many rms can be given to each channel assuming the resistance is 2 ohms, and how many rms can be output to the subwoofer ??
The P3001BT has two channels and the RMS 300 Watt @ 8 Ohm X 2. Subwoofer out is a Signal output it requires to have an active subwoofer
how wide is the unit with out the rack mounts
The P3001BT has a Width of 18.89"