Ultra Compact Phono Turntable Preamp
Extend Warranty Protection and Earn Rewards. Click HERE for Registration
QUESTIONS & ANSWERSAsk a Question
do you sell the preamp with an ac power adapter multivolt?
It says on the listing that the DC 12-Volt Power Adapter is Included but it does not say if it is multi volt
Can i use the 120ac to 12vdc power adapter for 240vac? Or need another? Thanks a lot Ricardo
You may use a different one that fits 240 VAC or you may use an auto volt 110 / 240 VAC to 12 VDC
I have no sound after setting up the preamp as instructed
Connect the Turntable out to the input jack of the PP444 then the output of the PP444 to any of the inputs on your receiver
Hi....is the power supply international? can it connect to 220 and 120V?
Hi there, thanks for asking!
Yes, it is! DC 12V power supplies or an adapter are some of the most common power supplies in use today. In general, a 12VDC output is obtained from a 120VAC or 240VAC input using a combination of transformers, diodes, and transistors.
Have a great day!
Can you please notify me when you have more in stock?
This is in stock
I purchased one of these from Amazon and it is model PP444 but it is missing the grounding connection. I am getting a lot of static and would like a model that can be grounded to the turntable. Would you provide me with a different model or tell me how to ground this model?
The ground screw was removed from its original design and what you can do is to loosen one screw near the input section and insert the ground wire and tighten it back again.
I am hooked into my DVD input on my Yamaha RX-V683 but no sound what am I doing wrong??? I am running through a PP444.
Make sure that the PP444 is receiving power through the DC 12-Volt Power Adapter.
Output of the Turntable to the INPUT of the PP444,
Output of the PP444 to the DVD INPUT of the Yamaha RX-V683
I bought the pp444 and it has a different ground. The ground is a solid hexagonal post that a ground wire doesn't seem to be able to connect to and I can't manipulate by hand. Is it just screwed in too tight?
It may have been screwed in too tight.