In-Wall / Wall Plate Speaker Selector PVCS2
Extend Warranty Protection and Earn Rewards. Click HERE for Registration
QUESTIONS & ANSWERSAsk a Question
How are speaker wires properly connected to the terminal block in the back of the PVCS2 speaker selection switch? Thank you
The middle Left and Right section is the input
When will these be back in stock? They've been out everywhere for months.
The order has been placed, We do not have an ETA on the replenishment!
I moved and brought my PVCS2 A-B speaker selector switches with me but don't remember how to hook them up. I had them working at my old house. At the new house, I only seem to be able to get one of each set of speakers working or find that one side is on the A switch and one is on the B switch. I know the leads for the inputs from my amplifier are in the center, but can't seem to figure out the L+ L- and R+ R-. I couldn't seem to be able to get both right and left speakers in one room working on the same switch. Can you provide a graphic showing the hock up for each set on speakers. Please help me? Thanks.
Please refer to the link below:
Can I use 16 gauge speaker wire with this switcher?
Yes, you can use 16AWG wire
Could þhis be used to switch between 2 sources to one set of speakers?
This is for a single source only
I want to connect to 8 speakers. I can daisy chain so that 2 speakers are connected to each speaker output?
this connection will vary depending on the impedance of the amplifier and the speaker