Portable Room Air Conditioner& Heater SLACHT128
Features:
What’s in the Box:
Technical Specs:
Extend Warranty Protection and Earn Rewards. Click HERE for Registration
QUESTIONS & ANSWERS
Ask a Question-
does this operate as a heat pump?
It generate heat but it does not pump
-
Is there a way to turn the operational beeping sounds off?
There is no option to turn off the beeping sound
-
What is the start up wattage in ac/heat modes ?
Approximately 1500 watts
-
The FL indicator keeps coming on and shutting down the unit. I have the drain tube continuously hooked up to drain constantly but it still shuts off..Help! Can I disconnect the sensor?
Please contact us through our email support system so we can direct you to the correct department. Simply Go to pyleusa.com click on the CONNECT tab then on the drop-down choose Contact Us. Fill out the form and in the last part, you will have an option to write your Subject, and also on the comment box, you can write your concern about the product. Please allow at least 12 to 24 hours for someone to get back to you. You can also contact our support hotline at 718-535-1800 ext 2 during weekdays from 9 am to 6 pm EST.
-
Does the exhaust duct assembly have to be used in the heater mode (and all other modes)? Also will the dehumidification drainage line be needed in all modes?
The exhaust is to let the heat out that it is producing when cooling the room. you may not connect the exhaust hose on heat mode
-
What is the SEER or CEER rating?
There is none mention on the documentation about the SEER or CEER rating
-
vertical installation
Yes
-
Should the drain hose be connected to the unit while just running the AC.
Yes the drain hose needs to be connected
-
does the exhaust pipe need to be hooked up when you have on fan mode?
No need to hook up the exhaust pipe
-
We purchased this unit this spring. The compressor has stopped working. The air flow is clear around the unit and the tube is fairly straight to the the outside.
Does the unit power on? If the motor does not run. Please check if your unit is still within 30day replacement warranty from seller. If not, you are covered by a one year warranty by the manufacturer but you would have to send the unit for evaluation and repair to our service center.
Please do not hesitate in contacting us through our email support system. Simply Go to pyleusa.com click on the CONNECT tab then on the drop-down choose Contact Us. Fill out the form and in the last part, you will have an option to write your Subject and also on the comment box you can write your concern about the product. Please allow at least 12 to 24 hours for someone to get back with you. You can also contact our support hotline at 718-535-1800 ext 2 during weekdays from 9 am to 6 pm EST -
When in cooling mode both the compressor and fan stop when the temperature is reached. Is there a way to keep jthe fan on all the time in cooling mode.
Please do not hesitate in contacting us through our email support system. Simply Go to pyleusa.com click on the CONNECT tab then on the drop-down choose Contact Us. Fill out the form and in the last part, you will have an option to write your Subject and also on the comment box you can write your concern about the product. Please allow at least 12 to 24 hours for someone to get back with you. You can also contact our support hotline at 718-535-1800 ext 2 during weekdays from 9 am to 6 pm EST.
-
the unit is drawing around 13 amps. the vent hose is attached a shared 6" vent hose going outside it is approximately 40 ' total with 5- 90 degree bends. Could this be causing the higher current flow, also the back of the unit is pretty hot.
Make sure that the air Flow hose does not choke the air going out otherwise it will cause pressure to the unit.
-
Your Portable Room Air Conditioner& Heater SLACHT128 Manual says: FILTER SCREEN • Vacuum the filter screen once every two weeks. If it is blocked by dust, efficiency of the A/C will be reduced. • Take out the air inlet grille and pull out the filter screen at both sides according to the direction shown in the following figures. Use vacuum to remove lint from filters. • Put the filter screen into the warm water (about 40°C or 104°F) added with neutral detergent, dry it at a shady place after cleaning. There are no "following figures" or any reference as to where the filter is or anything at all about it.
The Filter screen/Grill is at the lower back of the SLACHT128
-
Can this be stored (not operated) on its side?
it can only be stored upright
-
Will the window exhaust kit fit a window that is only 21.5 inches wide?
The unit comes with 2 window plates to make it fit with any window size